Tapco vertical grip reviews

Posted on by

I bought one of these to

I bought one of these tapco vertical grip to go on my quad rail for my Arsenal SGL-21 AK-47, and it went on perfectly. When mounted towards the front of the rail, it DOES NOT get in the way of loading or unloading magazines! Great product for anyone looking for an inexpensive vertical grip (fits on anything with a rail)!

No wobble after I mounted Rated 5 out of 5 stars

No wobble after I mounted the tapco vertical grip on my AK-47 quad rail. I think I will be picking up a low profile one for my AK and put this one on one of my other rifles, as I had to mount it very far forward so that it would not interfere with magazine changes. I am thrilled with the product. All parts were there, and it installed in about a minute.

I have this grip mounted Rated 5 out of 5 stars

I have this grip mounted on a WASR-10… recently, torture tested it in sand, mud, and total submersion, and the grip stayed utterly waterproof. The two batteries inside the storage compartment remained dry. It also fits nicely in hand… not too large or small in diameter. Excellent foregrip.

I Ordered this with TAPCO Rated 5 out of 5 stars

I Ordered this with tapco ak handguard. It goes on just like it was made for it and worked great with the TAPCO 20th mags. If you want to use 30th mags, it will take some time to get used to putting them in the Rifle, but it will work with them, and it works with the 40th mags if you have them.

I bought this a while back. Rated 4 out of 5 stars

I bought this a while back. I love it! Very sturdy, and makes the Rifle look intimidating. Very tight fit on the Tapco fusion stock. Doesn’t wiggle at all. The only reason for four bullets is that it gets in the way of the magazine if put in the far rear position, so it sits about the middle of the rail. Other then that, it’s great. I have another SKS that I may upgrade with a Fusion stock and grip, but I may go for a folding clasp instead.

Love this simple yet effected 5 out of 5 stars

Love this simple yet effective vertical foregrip. Easy to install and remove, holds a Lithium flashlight battery (maybe 2) in the sealed storage compartment, sides have enough flatness to accommodate pressure switches. Easy to customize as well for those that like to paint camo etc. on their parts. It accepts paint very well when sprayed on.

An excellent solid grip, the rated 5 out of 5 stars

An excellent solid grip, the waterproof compartment comes with o-rings to keep batteries from making contact and keeping things from rattling around. I assumed a threaded bottom sealed the chamber, but it’s just a rubber plug. The plug holds in nicely and hasn’t shown an issue of falling out. Good grip, you won’t be upset with this one.

Bought this for my RugerRated 5 out of 5 stars

I bought this for my tapco 10/22 stock. Mounted right onto my bottom Picatinny behind my Leapers UTG Bipod. Fits great and does not move an inch when you tighten it up. I was worried that this foregrip would interfere with my Butler Creek Steel Lips 25 round magazine, but it did not one bit, for anyone with a similar set-up that was worried about that!